Brought to you in part by:
Twelve Years!

...

Eighteen Years!
.

Click here to see a list of our Supporters.
  • If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Announcement

Collapse
No announcement yet.

HEI Module mounted on an AC Delco Heat Sink with Wiring for a DS11

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • HEI Module mounted on an AC Delco Heat Sink with Wiring for a DS11

    I have 1 Hei Module mounted on a AC Delco heat sink & a custom bracket. Includes wiring & has a radio noise capacitor wired into the circuit.
    The wiring can be connected to a DS11 distributor & connected to a MSD Blaster coil 2 or 3, the MSD is suggested because of the low ohms on the primary coil windings. The modules are BWD a quality part.
    A wiring schematic is included. No resistor needed, just a good 12 Volt source.
    The cost is $75.00 which includes shipping.
    I accept paypal & USPS Money orders. PM, email or call 843-202-0280. Note this phone is monitored 3 times daily, so leave a clear concise message. Bill

    .
Working...
X